High Performance Pushback Pallet Racks , Antistatic Pallet Racking Storage
Pushback Pallet Racks Brief Introduction
1. Push back storage rack has enjoyed rapid growth in popularity recently due to offering similar space savings as drive-in, with typically 3 to 5 times greater selectivity. This growth has been spurred by marketing trends such as rapid increases in number of SKUs, mass customization, and more rapid product obsolescence.
2. Each level in a push-back system holds a series of nested rolling carts, operating in a lane which slopes upward away from the pick face.
3. To load the lane, the first pallet loaded in the lane is loaded onto the top cart. To load the next pallet in the lane, the lift truck operator lines up in front of the first pallet and pushes against it, causing the first pallet to roll back away from the pick face, and exposing the next cart, which the second pallet can be lowered onto, once it's in position. The process is repeated until the lane is full. To empty the lane, the operator slowly removes the last pallet in, and the others roll back forward, down to the pick face. Similarly, the process continues until the lane is empty.
Pushback Pallet Racks detail
Cart - Bearings – Rails – Anti-Slip Steel – Rail Bracket – Front Stopper
Pushback Pallet Racks function
Push-back rack, also known as push-in rack, are connected by multi-layer carts between the front and rear beams. Stacked goods are pushed into the carts from the outside, and the stored goods will push the original goods into it. It is usually used in places where the storage space is extremely limited, but the storage capacity must be increased or the time required for the goods must be increased.
The track of the press-in rack has a certain slope, about 3 °. It uses the weight of the goods, and the pallet goods are specified for single-end storage. The total depth of this kind of rack should not be too deep, generally within the depth of 6 pallets, because the carts are embedded in each other, so they take up some space. The weight of a single pallet is generally within 1500kg, and the rack height is generally below 6m.
The press-in racking system has higher requirements for the manufacturing accuracy of the rack. Because the cooperation between the pallet cart and the guide rail is high, the manufacturing and installation accuracy is strict. Failure to do so will cause the racking system to run poorly and affect work effectiveness.
The cost of press-in rack is higher, which is directly proportional to its value. Its warehouse utilization rate reaches about 80%, and the space utilization rate of the warehouse can be improved.
It is more than 30% high, easy to access and flexible, and is the rack with the highest storage efficiency.
Pushback Pallet Racks application
- When storing and transporting goods, the forklift works only at the lower end of the rack aisle, and does not need to enter the rack goods storage aisle. Such shelves have the typical characteristics of high storage density and fast storage and transportation speed;
- It is usually used for storage places that are extremely limited, but it must be used in places where the storage requirements are not high, such as increasing storage capacity or requiring time for the goods.
Design Features
The track of the press-in rack has a certain slope, about 3 °. It uses the weight of the goods, and the pallet goods are specified for single-end storage. The total depth of this kind of rack should not be too deep, generally within the depth of 6 pallets, because the carts are embedded in each other, so they take up some space. The weight of a single pallet is generally within 1500kg, and the rack height is generally below 6m.
Product Tags:
|
|
High Performance Pushback Pallet Racks , Antistatic Pallet Racking Storage Images
|
